ELECTRIC MOTORS
TEFC - W22 NEMA Premium Efficiency
TEFC - General Purpose - NEMA 56
- Three-phase, II, IV or VI pole, 60Hz
- V-ring slingers on both end shields
- Designed to operate in any position
SOFT STARTERS
SOFT STARTER SSW-05
- Digital Signal Processor Control.
- Excellent performance during starting and stopping.
- Excellent cost/benefit ratio.
- Operator Interface allows easy parameter setting.
- Compact built, optimizing the space in electrical panels.
- Incorporates all protections for the driven motor.
SOFT STARTER SSW-06
- Static starters intended to accelerate, decelerate and protection of three phase induction motors.
- The control of the voltage applied to the motor by the means of the thyristors triggering angle variation allows the soft-start to start and stop an electric motor smoothly.
- With adequate adjustments of variables, the torque produced is adjusted to the needs of the load, so the required current is as low as possible for the starting procedure.
SOFT STARTER SSW-07
- DSP (Digital Signal Processor) control designed for high performance on motor starts and stops with an excellent cost-benefit ratio.
- Easy to set up
- It simplifies start-up activities and daily operation.
- Compact built to optimize space in electric panels.
- Electric motor protection.
- Adapts to customer needs through its easy-to-install optional accessories.
- A keypad, a communication interface or a motor PTC input can be added.
VARIABLE SPEED DRIVES
CFW08 VARIABLE SPEED
- The most advanced technology features in a compact product.
- Complete set of special functions available.
- Easy to install and operate.
- Equipped with optimized software that can be easily set through a keypad,
- Capable of processing and controlling most industrial machines.
- Equipped with dead time compensation technique to avoids motor instability and provides increase of torque at low speeds.
CFW700 GENERAL PURPOSE DRIVE
One of the main focus for WEG Drives is have a robust product for general purpose applications. The CFW700 is a high performance product with torque and speed control.
The power range:
1.5 to 2.2 kW (1.5 to 3 HP) 200-240 V – Single-phase
1.1 to 55 kW (1.5 to 75 HP) 200-240 V – Three-phase
1.5 to 132 kW (2 to 175 HP) 380-480 V – Three-phase
1.5 to 110 kW (2 to 150 HP) 500-600 V – Three-phase
CFW700 GENERAL PURPOSE DRIVE
- The most advanced technology features in a compact product.
- Complete set of special functions available.
- Easy to install and operate.
- Equipped with an optimized software that can be easily set through a keypad to process and control most machines.
- Equipped with dead time compensation technique to avoid motor instability and to provide increase of torque at low speeds.